1
Download Model 700 GC
Transcript
Model 700 MAINTENANCE AND TROUBLESHOOTINGTABLE OF CONTENTS 4-51 4. Loosen the thumb screws holding the valve in place. Model 700 TCD Upper Enclosure Figure 4-23 Stream Switching Assembly 5. Lift the solenoid off of the alignment pins (approximately 1/8”). 6. Slide out the solenoid block. 7. Disconnect the wire leads and remove the gasket from the bottom of the solenoid block. The solenoids are not polarity sensitive. JULY 2007 8. Replace the old leads at the connector plug or splice the wires from the new solenoid to the old leads. Solenoid Valve Replacement
