Download USER MANUAL - Suvik Electronics Pvt. Ltd.

Transcript
DIGITAL ‐ SERVO CONTROLLED VOLTAGE STABILIZER
Phase Sequence
error:
Carbon loss fault:
Manual or
Hardware error:
This is an optional feature. This feature is useful for
motor application. System will look for three phase
in correct sequence.
If user connects in wrong phase sequence than this
error message pop up and system will remain in
trip condition only.
This error message indicates that carbon is
breakdown in particular phase.
This message pops up when user place the SCVR
system in Manual mode or any hardware fault will
occur. System work healthy till Under/Over voltage
come. When output voltage cross Under/Over
voltage limits system will trip the load.
SUVIK ELECTRONICS PVT LTD
VER. 1.0
30‐OCT‐10
Correct the phase sequence by
change any two wire and restart.
If user still found this error
message than call CSD/Dealer for
troubleshooting.
If user found this error message
than user must have to call
CSD/Dealer for troubleshooting.
User must have to place the SCVR
system in AUTO mode. After
placing system in AUTO mode trip
will come out and restart the
load. After placing system in
AUTO mode and error is still than
call CSD/Dealer for
troubleshooting.
PAGE 12 OF 14