Download TALLY INTERFACE BOX User Manual

Transcript
VII.SETUP
Setup is required after initial installation. Setup may also be required after
changing external GPIs or GPOs.
Setup is performed using a computer running an off the shelf web browser such
as “Microsoft Internet Explorer” or “Netscape”. Connect the CAT5 cable from the
computer to the same ethernet hub that the GPI TALLY PROCESSOR is connected
to.
After launching the web browser, enter the IP address of the GPI TALLY
PROCESSOR to be setup. The GPI TALLY PROCESSOR Home Page will be
displayed.
A. Set Password
The default password, when shipped from the factory, is “controls”, all lower
case. The password is used to access all configuration screens.
GPI Tally Processor, Setup Manual
Page 7 of 44