Download ATi USER MANUAL
Transcript
TESTS AND TEST CONDITIONS Use the PC Editor’s ‘Measure’ button (together with a sample part) if you are unsure of how to choose the test conditions. Choosing Test Limits The test limits can be: % A nominal value together with + and – percentage limits. >< Minimum and maximum values > A minimum value only < A maximum value only Use the Editor’s ‘Measure’ button (together with a sample part) if you are unsure of the nominal value. Remember to click on the units of limits (mV or V) when entering absolute values as limits. Test limits should be set as close as possible to the nominal value in order to detect faults. A typical tolerance would be ± 5% PAGE 7-72 VOLTECH ATI USER MANUAL
Related documents