Download USER`S MANUAL - SewTrain.com

Function No. : 005
005. Bobbin Count
1) UP_COUNT
Function Name : Lower thread counter counting method
The method of counting for the lower thread shall be determined.
Counting by adding the number of finished sewing until reaching the target number (default value)
[ Contents ] Whenever sewing of a design is fully completed, the number is counted up.
[ Caution ]
2) DN_COUNT
The timing for lower thread replacement is not indicated.
Counting by reducing the number of finished sewing from the target number
[ Contents ] Whenever sewing of a design is fully completed, the number is counted down.
Setting 3) DESIGN_UP
Value
Counting by adding the number of finished sewing by design
[ Contents ] When there are many identical designs included within a pattern, the number is
counted by raising up the number whenever sewing of the design is completed.
[ Caution ]
4) DESIGN_DN
The timing for lower thread replacement is not indicated.
Counting by lowering the number of finished sewing from the target number
[ Contents ] When there are many identical designs included within a pattern, the number is
counted by lowering the number whenever sewing of the design is completed.
The initial value of the lower thread counter shall be set before use.
Function No. : 006
006. Prodct Count
1) DISABLE
Function Name : Use of products counter
It is to set use of products counter.
It is not to use the products counter
[ Contents ] Products counter is not used that informs products quantity whenever
each operation finishes figure increases once by one.
[ Caution ]
Setting
Value
2) ENABLE
Products counter on the LCD screen is not used.
It is to use the products counter. (Factory installed condition)
[ Contents ] Products counter is used that informs products quantity whenever each
operation finishes figure increases one by one.
119