Download 1. Control Panel Firmware Replacement
Transcript
SATEL VERSA 67 Code – 4-digit code that can be used to acknowledge voice messaging from the telephone keypad, if the INT-VG module is connected to the control panel. Acknowledgement of the voice messaging will cancel telephone notification of the event. User – a user having the INT-VG ACCESS right can be assigned to the telephone number. Thus, after acknowledgement of the voice messaging, the user will automatically get access to the voice menu, provided that the INT-VG module is connected to the control panel. 10.2 Event assignment Enter the following information for the events of which the control panel is to notify: • number of the text message by means of which messaging will be effected. If the messaging is to be effected in the form of text messages, the voice message assigned to the given text message will be used. • telephone numbers to which the messaging will be effected if an event occurs. 10.3 SMS/Pager messages The control panel makes it possible to program 64 different text messages to be used for messaging notification. The text messages are numbered from 1 to 64. After the CA-64 SM synthesizer or INT-VG voice module is connected, one voice message of 16 available, can be assigned to each text message. The voice messages are numbered from 0 to 15. The same voice message can be assigned to several text messages. 10.4 Starting the messaging 1. Enable the TELEPHONE MESSAGING option (see: GLOBAL OPTIONS). 2. Define the mode of dialing the telephone numbers (global option TONE DIALING; in case of the pulse dialing option – PULSE 1/1.5 (OFF 1/2)). 3. Determine whether the control panel, prior to dialing the number, should check the telephone line for dialing signal (global option NO DIAL TONE TEST). 4. Determine whether the control panel is to play back the voice message after going offhook, or 15 seconds after the dialing is completed (global option NO ANSWER TONE TEST). 5. Determine whether alarm clearing should cancel the messaging (global option CLEAR MESSAGING ON ALARM CLEARING). 6. Define the number of attempts made by the control panel to notify about the event (parameters ROUND COUNT and RETRIES NUMBER FOR ONE ROUND). 7. Program the following data for at least one telephone to which notification messages will be sent: – description, – telephone number, – messaging type. 8. Record (CA-64 SM) / record or synthesize (INT-VG) the voice messages which are to be used for messaging (see: CA-64 SM synthesizer or INT-VG voice module manual). 9. Define the content of text messages which are to be used for messaging. 10. Assign the voice messages to the text messages. 11. Determine of which events to which telephone numbers and by means of which messages the control panel is to notify. 12. Program additional parameters for messaging by means of text messages.