Download User`s Manual
Transcript
Connecting the trigger input terminal To input trigger signals from an external device, wire the cable to the EXT TRIG terminal as shown below. Use a flat-blade screwdriver to push the minus (–) button above the terminal, insert the wire and then remove the screwdriver. After finishing wiring, lightly pull the wire to make sure it does not come out. Internal Equivalence Circuit Item Description Number of channels 1 Input voltage range 0 to +24V max. (single-ended ground input) Threshold level +2.5V Hysteresis Approx. 0.5 V (+2.5 to +3 V) Connecting the alarm output terminal To output alarm signals, wire the cable to the ALARM terminal as shown below. Use a flat-blade screwdriver to push the minus (-) button above the terminal, insert the wire and then remove the screwdriver. After finishing wiring, lightly pull the wire to make sure it does not come out. 20 Item Description Number of channels 1 Maximum rating DC30V 0.5A or less Connecting the External I/O Terminal Internal Equivalence Circuit and Example of Wiring Connection ZR-RX20 User’s Manual