Download Just Add Software, LLC

Transcript
Next you will be asked if you wish
to configure the hardware as well
as the switch. Answer yes to set
up and configure the hardware or
no if you want to configure the
switch only.
The configuration now begins to
run. InstallerPro will attempt to log into the switch using the name and password specified
in the Switch Options control group. If the login is not successful, you will be prompted
that the login failed and the configuration will end.
Once logged into the switch, InstallerPro sends a few initial commands to set up the environment for the configuration session. If a Cisco “SG” series switch is being used, InstallerPro will then check to see if the switch is in switch mode or router mode. If switch
mode is being used (the default for all SG series switches except the SG500X), InstallerPro
detects this and displays the
prompt shown at the right.
The switch will then be put
into router mode and will reboot.
This will take several
minutes. Please click OK and
then wait for InstallerPro to
continue the configuration
once the switch is rebooted.
Do not attempt to do anything
else with the configuration at this time.
40