Download SCADAPack E Technical Overview

SCADAPack E Technical Overview
14.4
87
RTU Status
The following system status points are provided by the SCADAPack E RTU to indicate status of various
aspects of RTU operation.
Point
Type
Description
RTU Initialized
RTC Time Synchronized
RTC Time Invalid
DNP3 Protocol Driver Running
Engineering Mode
Local I/O Module Failure
System
Binary
Points
Local Input Power Supply Low
Local On-Board Battery Low
Local Calibration Parameters Invalid
Hex Switch Settings Changed
(SCADAPack ES / SCADAPack ER only)
Task Software Watchdog
Time Zone Modifier
Configuration Corrupt
Trend Storage Priority
SCADAPack E Smart RTU Type
Firmware revision
Switch Setting (SCADAPack ES / SCADAPack ER
only)
Processor Board PAL revision
Processor Board Boot Monitor revision
I/O Board Firmware revision
System
Analog
Points
Hardware revision ID
Up Time (Secs)
Up Time Delta (0-1000 ms)
Reset/Error Reasons Mask
Task Watchdogs Mask
Engineering Timer
System Error Code
RTU Dynamic System Memory Free