Download MCF5373 Reference Manual
Transcript
FlexCAN Table 22-15. CAN Standard Compliant Bit Time Segment Settings (continued) 22.4 Time Segment 1 Time Segment 2 Re-synchronization Jump Width 8 .. 15 7 1 .. 4 9 .. 16 8 1 .. 4 Initialization/Application Information Initialization of the FlexCAN includes the initial configuration of the message buffers and configuration of the CAN communication parameters following a reset, as well as any reconfiguration that may be required during operation. The FlexCAN module may be reset in three ways: • Device level hard reset—resets all memory mapped registers asynchronously • Device level soft reset—resets some of the memory mapped registers synchronously (refer to Table 22-1 to see which registers are affected by soft reset) • CANMCR[SOFT_RST] bit—has the same effect as the device level soft reset Soft reset is synchronous and has to follow an internal request/acknowledge procedure across clock domains. Therefore, it may take some time to fully propagate its effects. The CANMCR[SOFT_RST] bit remains asserted while soft reset is pending, so software can poll this bit to know when the reset has completed. Also, soft reset can not be applied while clocks are shut down in any of the low power modes. The low power mode should be exited and the clocks resumed before applying soft reset. The clock source, CANCTRL[CLK_SRC], should be selected while the module is in disable mode. After the clock source is selected and the module is enabled (CANMCR[MDIS] bit cleared), the FlexCAN automatically enters freeze mode. In freeze mode, the FlexCAN is un-synchronized to the CAN bus, the CANMCR register’s HALT and FRZ bits are set, the internal state machines are disabled, and the CANMCR register’s FRZ_ACK and NOT_RDY bits are set. The CANTX pin is in recessive state and the FlexCAN does not initiate any transmission or reception of CAN frames. The message buffers are not affected by reset, so they are not automatically initialized. For any configuration change/initialization, the FlexCAN must be in freeze mode (see Section 22.1.3.2, “Freeze Mode”). The following is a generic initialization sequence applicable to the FlexCAN module: 1. Initialize all operation modes in the CANCTRL register. a) Initialize the bit timing parameters PROPSEG, PSEGS1, PSEG2, and RJW. b) Select the S-clock rate by programming the PRESDIV field. c) Select the internal arbitration mode via the LBUF bit. 2. Initialize message buffers. a) The control/status word of all message buffers must be written as an active or inactive message buffer. b) All other entries in each message buffer should be initialized as required. 3. Initialize RXGMASK, RX14MASK, and RX15MASK registers for acceptance mask as needed. MCF5373 Reference Manual, Rev 3 22-28 Freescale Semiconductor
Related documents
MCF5329 - Reference Manual
MCF5208RM, MCF5208
Motorola ColdFire MCF5281 Specifications
MCF5235RM, MCF5235
MCF5485 Reference Manual - Freescale Semiconductor
NetBurner User`s Manual - Bluewater Designworks, LLC
User Manual
AN2866:Migrating from the MC68332 to the ColdFire MCF523x
View/Open - Oregon State University
BlueNRG(-MS) - STMicroelectronics