Download "user manual"
Transcript
Chapter 4 Installation Determining the Space Requirements The decoder and scan head are separate units that can be mounted in different locations. A 10 foot (3 meter) or 25 foot (7.6 meter) cable is used to connect the two units. Figure 4.1 illustrates the dimensions of the scan head. Figure 4.1 Mounting Dimensions of the Scan Head 10–32UNF–2B x .31 2.69 in 6.83 cm 5.38 in 13.67 cm 2.69 in 6.83 cm Back View 2.20 in 4.75 in 3.00 in 4.75 in 12.07 cm 7.62 cm 12.07 cm Front View 5.59 cm 3.19 in 8.05 cm 10–32UNF–2B x .31 1.357 in 3.45 cm 2.69 in 6.83 cm 1.33 in 3.38 cm 4.75 in 3.00 in 4.75 in 12.07 cm 7.62 cm 12.07 cm 12.5 in 31.75 cm Bottom View Mounting the Scan Head Before installing the scan head, review the following information: • • • • Determine the optimum position of the scan head relative to the labels that are to be read. Refer to Chapter 3 for positioning information. If you are using the optional swivel base or brackets, add their dimensions into your positioning calculations. Allow a minimum clearance of 8 inches (20.3 cm) at the rear of the scan head so you can attach the cables to the various ports. Securely mount the scan head to a rigid surface to ensure proper operation of the scanning mechanism. The thickness of your mounting surface determines the length of the screws or bolts required. You will need two 10–32 screws, with flat and split washers. Select a length that equals the thickness of the mounting surface, thickness of the washers plus the depth of the screw holes, 3/8–inch (9.5 mm). 4–2