Download "user manual"

Transcript
3
Table 3-7. Place and Route - Xilinx
Option
Description
Setup your place and route options and invoke the Xilinx M1 tools. This P&R tab is available after you load the
Xilinx library, complete the design flow, and write an output netlist file.
Execute Place Route - Startup the DesignManager
Effort
Standard
Uses standard effort to
perform place and
route.
Generate Files for timing
simulation
Generate bit file
High
Performs place and run
for better results than
Standard, but takes a
longer time to run.
After the EDIF place and route, then run the SDF, VHDL or Verilog files
through back annotation to simulate the router design.
Select this box to generate a bit file after place and route to program a Xilinx
device. Not selected by default.
Use bitgen command file:
Select this box to open Bit Gen Command File or type in a file name.
This file contains options for Xilinx bit file generator. Not a default.
Only generate a netlist for
functional simulation.
Only generates a VHDL or Verilog file. A SDF timing file is not needed.
Only generate pre place &
route delay estimate
Select if you want to generate and estimate of place and route instead of
actually doing a place and route.
Run Design Manager
Gate Level back annotation
Install path for Place_route exec:
Select if you want to run the Xilinx M1 GUI.
Select this box if you want to do gate level with your EDIF file. Use an
NGM file with ngdanno to perform gate level back annotation. Not a default.
This is the path to the directory where your Xilinx M1 executable is
installed. If Xilinx environment variable is set or if the executable is in your
path then leave this field blank.
Back Annotated Timing Analysis
Simulation: Alliance generates VHDL or Verilog
VHDL
Write Output For:
Verilog
simulation netlists to target the simprim or neoprim
primitive cell set, and to generate an SDF file for back
annotated timing.
Click Run PR to invoke Xilinx M1 tools using specified options.
3-16
LeonardoSpectrum User’s