Download "user manual"
Transcript
3 Table 3-7. Place and Route - Xilinx Option Description Setup your place and route options and invoke the Xilinx M1 tools. This P&R tab is available after you load the Xilinx library, complete the design flow, and write an output netlist file. Execute Place Route - Startup the DesignManager Effort Standard Uses standard effort to perform place and route. Generate Files for timing simulation Generate bit file High Performs place and run for better results than Standard, but takes a longer time to run. After the EDIF place and route, then run the SDF, VHDL or Verilog files through back annotation to simulate the router design. Select this box to generate a bit file after place and route to program a Xilinx device. Not selected by default. Use bitgen command file: Select this box to open Bit Gen Command File or type in a file name. This file contains options for Xilinx bit file generator. Not a default. Only generate a netlist for functional simulation. Only generates a VHDL or Verilog file. A SDF timing file is not needed. Only generate pre place & route delay estimate Select if you want to generate and estimate of place and route instead of actually doing a place and route. Run Design Manager Gate Level back annotation Install path for Place_route exec: Select if you want to run the Xilinx M1 GUI. Select this box if you want to do gate level with your EDIF file. Use an NGM file with ngdanno to perform gate level back annotation. Not a default. This is the path to the directory where your Xilinx M1 executable is installed. If Xilinx environment variable is set or if the executable is in your path then leave this field blank. Back Annotated Timing Analysis Simulation: Alliance generates VHDL or Verilog VHDL Write Output For: Verilog simulation netlists to target the simprim or neoprim primitive cell set, and to generate an SDF file for back annotated timing. Click Run PR to invoke Xilinx M1 tools using specified options. 3-16 LeonardoSpectrum User’s