Download powerTWO User Manual

Transcript
Freq User Inputs
Freq user inputs measure the frequency of a logic input, i.e. how often the logic input changes.
UserIOs 0 & 1 measure frequencies up to 10 kHz and require an input high level of 11.5 Volts or
more. UserIOs 2 to 7 measure frequencies up to 200 Hz.
Freq user inputs provide the frequency value, the associated step value and steps as output.
The following example is a frequency input calibrated to a magnetic sensor on a driveshaft.
With a 3.43 differential & 20" tire (5.24 ft. in circumference)
1 shaft rev = 5.24/3.43 = 1.53 ft
88 fps (60mph) = 57.6 Hz
We‟ve chosen steps at 176 fps and 220 fps (120 and 150 mph), as follows:
When created, the Freq input appears as on the right.
See the “Units Management section” for Units selection and definition and for calibration.
powerTWO User Manual
28