Download DoubleSense Model III User Manual

Transcript
2.
To register when a paper is in the sensor, i.e. at position A (positive flank) to B
(negative flank).
3.
To detect the paper passing time, i.e. the time between positive and negative flank .
4.
To detect missing sheets, i.e. IF NOT Paper Present THEN Missed sheet. (alternative to
using the Trig Input and the Stop Error Output for missing sheets).
The diagram below shows the Paper Present Output active. The output has a 4 ms filter for
lead edge detection and 4 ms filter for trail edge detection.
A
B
Paper Present Output
Edge filter 4 ms
Edge filter 4 ms
Diagram 18. Signal scheme for Paper Present output signal.
6.3
Logic Output signalling
The Logic output signalling is an array of logic combinations providing the user with
information on all 16 occurring error types and operation modes. The 4 outputs create a logic
array where each output will have the value of a digital “1” or “0”. When combined the errors
or states will be indicated.
“1”=Active output
“0”=Deactive output
Signal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
Detection Mode
Paper Present
Double Off Mode
Calibration Mode
Layer Error
67% Paper pass time
150% Paper pass time
Too dark or too thick paper
Pass time 10/1 of calibration pass time
Pass time 1/10 of calibration/Halt active during calibration
>5 seconds, Maximum pass time exceeded
Incomplete calibration, continued calibration required
<23 ms + paper edge delay, Minimum time error
Missed sheet
Paper Jam
Double sheet
©Svensk Elektronikproduktion AB
Output
1
0
0
0
0
0
0
0
0
1
1
1
1
1
1
1
1
2
0
0
0
0
1
1
1
1
0
0
0
0
1
1
1
1
3
0
0
1
1
0
0
1
1
0
0
1
1
0
0
1
1
4
0
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1
Page 29(43)