Download DoubleSense Model III User Manual
Transcript
2. To register when a paper is in the sensor, i.e. at position A (positive flank) to B (negative flank). 3. To detect the paper passing time, i.e. the time between positive and negative flank . 4. To detect missing sheets, i.e. IF NOT Paper Present THEN Missed sheet. (alternative to using the Trig Input and the Stop Error Output for missing sheets). The diagram below shows the Paper Present Output active. The output has a 4 ms filter for lead edge detection and 4 ms filter for trail edge detection. A B Paper Present Output Edge filter 4 ms Edge filter 4 ms Diagram 18. Signal scheme for Paper Present output signal. 6.3 Logic Output signalling The Logic output signalling is an array of logic combinations providing the user with information on all 16 occurring error types and operation modes. The 4 outputs create a logic array where each output will have the value of a digital “1” or “0”. When combined the errors or states will be indicated. “1”=Active output “0”=Deactive output Signal 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Detection Mode Paper Present Double Off Mode Calibration Mode Layer Error 67% Paper pass time 150% Paper pass time Too dark or too thick paper Pass time 10/1 of calibration pass time Pass time 1/10 of calibration/Halt active during calibration >5 seconds, Maximum pass time exceeded Incomplete calibration, continued calibration required <23 ms + paper edge delay, Minimum time error Missed sheet Paper Jam Double sheet ©Svensk Elektronikproduktion AB Output 1 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 2 0 0 0 0 1 1 1 1 0 0 0 0 1 1 1 1 3 0 0 1 1 0 0 1 1 0 0 1 1 0 0 1 1 4 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 Page 29(43)