Download E1339-90001

Transcript
ARM Subsystem
The ARM subsystem allows a scan list to be scanned multiple times (1 through
32,767) with one INITiate command.
Syntax
ARM
:COUNt < number > MIN|MAX
:COUNt? [MIN|MAX]
ARM:COUNt < number > MIN | MAX
Allows scanning cycles to occur a multiple of times (1 to 32767) with one INITiate
command when INITiate:CONTinuous OFF |0 is set. MIN sets 1 cycle and MAX
sets 32767 cycles.
Parameters
Parameter Name
Parameter Type
Range of Values
Default Value
number
numeric
1-32767|MIN|MAX
1
Comments
• Number of Scans: Use only values between 1 (MIN) and 32767 (MAX) for
the number of scanning cycles.
• Related Commands: ABORT, INITiate[:IMMediate], INITiate:CONTinuous
• *RST Condition: ARM:COUNt 1
Example
Example: Setting Ten Scanning Cycles
This example sets a Relay Driver Module for 10 scans of channels 0 through 3. For
72-channel mode, when the scan sequence completes channels 0 through 3 are
closed. For 36-channel mode, when the scan completes channels 0 through 3 SET
are closed and channels 0 through 3 RESET are open.
ARM:COUN 10
SCAN (@100:103)
INIT
62
Relay Driver Module Command Reference
!Set 10 scans per INIT command
!Scan channels 0-3
!Start scan, close channel 0