Download E1339-90001
Transcript
Comments • Closing Channels: To close: - a single channel use ROUT:CLOS (@ccnn); - multiple channels use ROUT:CLOS (@ccnn,ccnn,...); - sequential channels use ROUT:CLOS (@ccnn:ccnn); - groups of sequential channels use ROUT:CLOS (@ccnn:ccnn,ccnn:ccnn); - or any combination of the above. • Closure Order not Guaranteed: Closure order for multiple channels with a single CLOS command is not guaranteed. A list of channels will not all close simultaneously. The order in which channels close when specified from a single command is not guaranteed. Use sequential CLOSe commands if needed. Example • Related Commands: [ROUTe:]OPEN, [ROUTe:]CLOSe? • *RST Condition: All channels are open in 72-channel mode. In 36-channel mode, all SET channels are open and all RESET channels are closed. Example: Closing Relay Driver Module Channels This example closes channels 00 and 13 of a two-module switchbox (card numbers 01 and 02). CLOS (@100,213) ! Close channels 100 and 213. In 72-channel mode, 100 closes channel 0 of card #1 and 213 closes channel 13 of card #2. ! In 36-channel mode,100 closes channel 0 SET and opens channel 0 reset, while 213 closes channel 13 SET and opens channel 13 RESET for card #2. [ROUTe:]CLOSe? <channel_list > Returns the current state of the channel(s) queried. Channel_list has the form (@ccnn) where cc = card number (01-99) and nn = channel number (00-71 for 72-channel mode or 00-35 for 36-channel mode). The command returns "1" if channel(s) are closed or returns "0" if channel(s) are open. Comments • Query is Software Readback: The [ROUTe:]CLOSe? command returns the current software state of the channel(s) specified. It does not account for hardware failures or for channels opened or closed by direct register access (see Appendix B - Relay Driver Module Register Definitions). Relay Driver Module Command Reference 75