Download CN100 User`s Manual

Transcript
Compass Networks
2. Copy new CN100Manager.exe to the specified folder to replace the
CN100Manager.exe file
3. Run CN100 Manager Software
4. Verify Version by clicking help found on the top right of the main screen.
3
Configure Chassis IP Address
The following instructions define how to configure the IP address of the Tester using the Manager
software. You will need a straight thru DB9 cable for RS232 Serial port Connection and a CAT 5 Ethernet
cable to use the Ethernet Port. (To connect the tester directly to your computer an Ethernet crossover cable
is required)
1.
2.
From the Main Screen select Operations, ConnectionSetup.
Select Use Serial Port (need serial connection to configure tester IP address)
3. Select Change Tester IP:
Local Host IP- Displays Local Host IP address
Note-The Chassis Current IP address is displayed on the LCD of the Chassis
CN-100 User Manual
8