Download ACU-100

Transcript
ACU-100
SATEL
5
RS-232 port with opto-isolation. It enables a PC computer with DLOAD10 program to be
connected for the time of programming.
RJ type socket. It allows to connect an LCD keypad for the time of programming. The
controller interfaces with LCD keypads for operating the CA-64 or INTEGRA / INTEGRA
Plus series control panels.
Notes:
 The controller cannot be simultaneously programmed by means of computer and LCD
keypad.
 When working with the INTEGRA, INTEGRA Plus or VERSA alarm control panels, the
controller can be programmed by means of the control panel, with no need for connecting
the keypad or computer to the controller sockets.
tamper contact. It is activated by enclosure cover removal.
LED indicator. It indicates the controller status. The mode of lighting depends on the
controller working configuration:
 interaction with CA-64, INTEGRA, INTEGRA Plus or VERSA alarm control panels:
 green steady light – no communication with the control panel;
 green blinking light – correct communication with the control panel.
 interaction with other alarm control panels:
 green steady light – normal operation of the controller;
 green blinking light – synchronization in the process;
 alternate green and red blinking light – occurrence of one of the problems signaled
on functional outputs (see: FUNCTIONAL OUTPUTS).
LED indicators of output status.
Description of terminals:
COM
- common (ground).
+12V
- power supply input.
TMP
- controller tamper terminals (NC). You can use the TMP terminals in two
ways:
 connect the terminals to the tamper circuit of the control panel;
 connect one of the TMP terminals to the ITMP tamper circuit input, and
the other to the COM ground terminal – information of the controller
tamper will be fed to the TPR output and to the communication bus.
ITMP
- input for connecting controller tamper circuit.
Note: If the TMP terminals are not connected to the controller tamper circuit, the ITMP
terminal must be shorted to the common ground.
information output – tampers.
information output – no radio communication with wireless devices.
information output – radio jamming.
information output – problems with wireless devices power supply or with
supply output overload in the ACX-201 expander.
OUT1…OUT8 - information output – wireless equipment status.
AR1…AR4
- control inputs.
A RS485 B
- RS-485 port terminals (not used).
TPR
CON
JAM
LBA
-