Download FL-PR5

Flash Memory Programmer FL-PR5 User’s Manual (Provisional)
SBA1-070002-00
115/138
The following are the recommended connectors (male) to be connected to 16-pin 2.54 mm pitch multipurpose
female connectors.
 HIF3FC-16PA-2.54DS (made by Hirose Electric Co., Ltd., right angle type)
 HIF3FC-16PA-2.54DSA (made by Hirose Electric Co., Ltd., straight type)
 7616-5002PL (Sumitomo 3M Limited, right angle type)
 7616-6002PL (Sumitomo 3M Limited, straight type)
When using a self-made cable because the supplied cable cannot be used due to the target system specifications,
the cable characteristics should be equivalent or higher than those of the supplied cable.
Note that communication may be performed at high speed depending on the communication settings.
Consequently, communication errors may occur and causing abnormal operation.
7.5
GND Connector
The banana jack GND connector is laid out on the target connector side of the FP5.
Figure 7-13.
GND Connector <FP5 Target Connector Side>
GND connector
Part number of GND connector (banana jack): PB4 (HIRSCHMANN)
7.5.1
GND cable
The host cable is a standard shielded GND cable approximately 1 meter long.
The GND cable is equipped with
a banana jack and a spade terminal.
Caution The FP5 and target system may be damaged if the voltage between the FP5 GND and the target
system GND is different. Use the GND cable to match the voltage before connecting the target
cable.
Figure 7-14.
GND Cable Outline
Banana Jack
Spade terminal
Part number of banana jack: TJ-2167 (made by Sato Parts Co., Ltd.)
Part number of spade terminal: BPF1.25-3 (red) (Daido Solderless Terminals Mfg. Co., Ltd.)