Download Philips 202p7

Transcript
DDC Instructions
202P7 CRT
27
Go to cover page
2. Access Factory Mode
1). Turn off monitor(don't turn off PC)
2). Press
and simultaneously on the front control pane,
then press , wait until the OSD menu with characters
P72 FAMILY V0.10 20050104 (below OSD menu) come on the
screen of monitor (see Fig. 23).
Factory
Mode------------Indicator
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
in other IC chip. To save DDC data, follow the steps below:
1. Click
(Save) icon (or click "file"-> "save as") from the tool bar
And give a file name as shown in Fig. 25.
The file type is EDID46 file (*.ddc) which can be open in WordPad.
By using WordPad, the texts of DDC data & table (128 bytes, hex
code) can be modified. If DDC TEXTS & HEX Table are completely
correct, it can be saved as .ddc flie to re-load it into DDC IC for DDC
Data application.
Fig. 25
2.
Click Save.
Fig. 23
3). Push "Menu" to exit OSD menu.
4). Click (Write EDID) icon from the tool bar to write DDC data,wait
for 10-15 seconds ,DDC data will be finished Writing.
Step 7: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 26.
3. Confirm Serial Number in User Mode
1) Press the
button to turn off the monitor. Press the
button
again to turn on the monitor.
2) Press the
button to bring up the OSD main menu.
3) Press the
button to select Extra Controls, press the
button to
confirm your selection.
4) Confirm the Serial Number ''TY 001440'' is updated as shown in
Fig. 24.
Fig. 26
Step 8: Turn off the monitor, exit the factory mode.
Fig.24