Download INSTALLATION INSTRUCTIONS

8.
Using a tape measure, mark the heater harness at
the measurements A, B, C, and D.
250 mm
(9.8 in.)
195 mm
(7.7 in.)
WHITE
MARKER
10. Locate and remove the drain bolt and washer.
Coolant remaining in the engine jackets flows out of
the hole when the drain bolt is removed. Retain the
drain bolt; it will be used if the engine block heater is
removed.
NOTE: Use a new washer if the drain bolt is
reinstalled.
100 mm
(3.9 in.)
A
B
C
D
320 mm
(12.6 in.)
HEATER
HARNESS
QC71109AH
9.
Install one wire tie with clip on the heater harness at
the white mark (point C).
DRAIN BOLT
(Retain.)
(Use a 19 mm
socket.)
WIRE TIE
WITH CLIP
(Point C)
FRONT
WASHER
(Discard.)
BOTTOM VIEW
QC71111AH
HEATER
HARNESS
QC71110AH
© 2014 American Honda Motor Co., Inc. – All Rights Reserved.
AII 51184 (1404)
5 of 10