Download Vehicle install

2
FleetLINK Fuel Control System
For Driver’s Safety
During installation of FleetLINK equipment:
• DO NOT tamper with vehicle brake and steering
systems! This may affect vehicle safety.
• Never attach wires, cables or other parts to steering
column, brake system cables and conduits, or to
any moving mechanical part.
• Route cables safely and do not allow any looseness.
For Installer’s Safety
• When performing work in the engine compartment,
STOP THE VEHICLE ENGINE to prevent severe
injury or death.
• Make sure no one will start engine while any work is
in progress. Remove the ignition keys if possible.
• Use only adequately rated, properly approved
equipment to elevate vehicles. Observe all safety
precautions when working under vehicles.
• NEVER WORK UNDER A VEHICLE SUPPORTED
ONLY BY A TIRE CHANGING JACK.
• Use tire blocks (chocks) whenever vehicle is
parked for installation procedures. Use traffic safety
cones to warn other drivers of stationary vehicles.
• Vent exhaust from enclosed areas.
W a r ni ng s :
12/10/01