Download 2000 User Guide - Xitron Technologies

Charging the Battery
21
Warning: Prior to recharging the internal battery disconnect the 2000 instrument from any intrinsically-safe process control system. Charging while connected could adversely affect the safety of the process control system.
Charging Modules
One of these modules is included with the main unit (as specified at the time of
order). Additional charging modules may be obtained using the codes described
below.
“M02000”
This option delivers an additional copy of this user guide. If not included at the
time of placing the order for the basic unit, please have the serial number of your
unit available when making this order.
“MS2000”
This option delivers a full service manual, incorporating schematics, assembly
diagrams, fault diagnosis aids and full servicing information. If not included at
the time of placing the order for the basic unit, please have the serial number of
your unit available when making this order.
“SP48”
A 48” long shielded cable with low thermal spade lugs terminating each lead. Use
this leads for applications requiring superior performance at levels below 1μV.
“PL36”
A 36” long shielded cable with low thermal plugs terminating each lead. This
lead should be used for applications requiring superior performance at levels below lµV.
“T1”
A wall-mount charger with 120VAC input and 12VDC @ 1.5A minimum output.
(This version has been obsoleted; The T5 is the recommended replacement)