Download BRAHMA BRAHMA

Mounting Main Frame Asy. To Tractor
3. If the Teflon sheathing is pushed out by a pin, the bearing must be replaced immediately.
4. DO NOT USE ANY KIND OF LUBRICANT - If problems continue, do not use any kind of
lubricant to aid the installation of the pin (it will only attract dirt, becoming liquid sandpaper, and
definitely destroy the bearing) Contact your dealer, or Alamo Group Technical Services.
MOUNTING ARM, RH MOUNTING BRACKET & UNDER BEAM
INSTALLATION:
These components will be assembled off the tractor and then installed as an assembly
to the tractor. Show below as disassembled as reference only and as general location of parts.
The LH Frame Mounting bracket WILL NOT be assembled with the arm assembly, it will
be installed after Arm, RH mounting bracket and under beam are installed. The Clamp plate to
mount the under beam to the LH mounting bracket will be installed after the arm, bracket and
under beam asy are installed. (See Figure 2)
Figure 2
General Illustration Shown for General information
NOTE: Shown in Figure 1 & 2 as disassembled as reference only, these components will be
connected to tractor as an assembly.
Brahma (JD -6120/6220/6320/6420 Asy. Manual) 06/04
© 2004 Alamo Group Inc.
Page 4 - 3