Download Ziehm 8000

6
Switching the System On and
Off
6.1
Preparing the system
Before switching on the system, e.g. after a transport, you must connect
the two system components to each other and also connect the entire
system to the power supply.
WARNING
Never connect the monitor cart and C-arm stand when the
monitor cart is already connected to the power supply or
switched on.
Damage to the electronics of the system cannot be
excluded if this warning is ignored!
To prepare a Ziehm 8000, do the following:
Ziehm 8000
• Unwind the coupling cable from the upper cable support on the back
of the monitor cart (→ Fig. 2-2, p. 2-7).
• Plug the coupling cable connector into the socket located at the side
of the C-arm stand and lock the connector by pulling the locking lever
upward (→ Fig. 2-1, p. 2-6).
• Make sure that a suitable supply voltage is available and that the
socket-outlet is properly grounded and fused.
• Check the power plug on the monitor cart power cable (→ Fig. 2-2,
p. 2-7) and the socket-outlet for compatibility.
• Connect the system to the power supply.
• Make sure that the inclination of the system does not exceed 5° from
the level in operating position.
• Put on suitable protective clothing.
• DICOM: Connect the DICOM port(s) on the back of the monitor cart
to a DICOM network socket using the appropriate cable(s).
Ziehm 8000
P_26376/CD_28210 - EN - 01/07/2010
6-1