Download Operating, Programming & Troubleshooting the EP Express Controller

Transcript
Chapter 4. Testing and Troubleshooting
BICJHT01 (Published) Book specs- Dates: 20070531 / 20070531 / 20070531 Lang: ENG01 Applic: CJX
4.1. Error Messages
4.1.1.
Error Messages at Power Up
If an error message appears during power up, the error must be cleared before the machine can be
run or programmed.
Display or Action
Explanation
The microprocessor performs a memory check each time the
machine is turned on. This error message appears if the
microprocessor detects that the accumulator data is corrupt, in
which case all accumulators must be reset to zero.
ACCUMULATOR ERROR
TERMINATE TO CLEAR
z
CHECKSUM ERROR,
TURN KEY TO PROGRAM
Resets all accumulators and clears the error message. See
“Viewing and Clearing the Formula Count Accumulator” (see
Table of Contents) for more information.
Appears if there is illegal data in the configuration, formula, or
industry memory areas. Use the following procedure to clear this
error.
1. Reconfigure the machine according to the configuration information in “Programming the E-P
Express® Control” (see Table of Contents).
2. Reinstall the standard (default) formulas according to the default formula loading procedure in
“Programming the E-P Express® Control”.
3. Reprogram any lost wash formulas according to “Programming the E-P Express® Control”.
MEMORY: FLASH
IS NOT TALKING
This message appears when the microprocessor cannot read from
the flash memory.
1. Lock off and tag out power to the machine.
2. Replace flash memory. Contact the Milnor® factory to ensure that the replacement memory is
the most current version for your machine.
3. Restore power to machine.
4. Reconfigure the machine according to the configuration information in “Programming the E-P
Express® Control” (see Table of Contents).
5. Reinstall the standard (default) formulas according to the default formula loading procedure in
“Programming the E-P Express® Control”.
6. Reprogram lost wash formulas according to “Programming the E-P Express® Control”.
PELLERIN MILNOR CORPORATION