1
Download ACT Plus®
Transcript
Medtronic Confidential CS0010 ACT_A.fm 6/25/12 3:25 PM 5.5" x 7.75" (139.7 mm x 196.85 mm) Procedure for setting the defaults: 1. To ensure that the scanner is reset, first scan the Set All Defaults bar code. Figure 18. Set All Defaults bar code 2. Scan the “Low Volume” bar code, unless a different volume is desired. Figure 19. Low Volume bar code 3. Scan the "Transmit Code ID" barcode to allow the barcode scanner to transmit the ID of Barcode format along with the data of the barcode that was just scanned. Figure 20. Transmit Code ID 4. Scan the “Enable UCC/EAN-128” bar code. The cartridges and controls use this format. Figure 21. Enable UCC/EAN-128 bar code 5. Scan the “Scan Prefix” bar code, then scan the following numbers: 1, 0, 0, 2. Figure 22. Scan Prefix bar code Figure 23. 1 bar code ACT Plus® Operator’s Manual M938504A002 Rev B English 63
