Download 845Z Injection Module User's Guide

Table of Contents
Declaration of Conformity
1 Introduction
Unpacking ............................................................................. 1-2
Customer Service ................................................................. 1-3
Technical Specifications ..................................................... 1-4
2 Installation
Installing the Injection Module ......................................... 2-2
Removing the Tubing Support Rod ........................... 2-2
Mounting the 845Z Injection Module ....................... 2-3
Installing the 845Z Control Unit ................................ 2-3
Making Electrical Connections ......................................... 2-4
845Z Control Unit Rear Panel .................................... 2-4
Unit ID Selection ........................................................... 2-5
GSIOC Port ..................................................................... 2-6
Input/Output Port ........................................................ 2-7
Power Connections ....................................................... 2-9
Making Plumbing Connections ......................................... 2-10
Sample Loop .................................................................. 2-10
Column and Pump Tubing ......................................... 2-10
Syringe Pump and Probe Tubing ............................... 2-11
3 Operation
Start-Up ................................................................................. 3-2
Front Panel ..................................................................... 3-2
Injection Technique ............................................................. 3-3
Total Loop Fill ................................................................ 3-3
Liquid Flow Path ................................................................. 3-4
4 Maintenance
Replacing the Rotor Seal and Stator Face Assembly .... 4-2