Download EC-Control User Manual

Transcript
EC-Control User Manual - Installation
USB relay box
(external signalling of failures)
UPS
Optional
Optional
Optional
IP address, e.g.
192.168.0.1
Ethernet / TCP/IP
Ethernet switch
IP address, e.g. IP address, e.g. IP address, e.g.
192.168.0.2
192.168.0.3
192.168.0.4
Fig. 2-2 Large size fab
Several Ethernet/RS485 interface converters are connected via a switch to the network card of the
computer. The individual network segments are called subnets. Monitoring of the clean room fans is
safeguarded by a UPS (Uninterruptible Power Supply).
All fans are connected to the interface converter concerned in either a linear or a star configuration. The
printer and a second monitor are optional. Only fans of the same bus system (ebmBUS or MODBUS)
are to be connected to each interface converter. However, it is possible to combine different bus
systems within one fab. EC-Control currently permits a maximum of four interface converters with
MODBUS and a maximum of four interface converters with ebmBUS in one fab.
This configuration increases reliability and interrogation rate and is therefore particularly well suited to
monitoring large-scale clean room fabs. In this case, it is also advisable to safeguard the computer with
a UPS to enable the fab monitoring system to register the fab status without any time delay in the event
of power failure.
General rule:
In fabs with more than 31 fans, it may be necessary to use RS485 repeaters (article no. 25708-1-0174)
depending on the type of fan.
12