Download EC-Control User Manual

EC-Control User Manual - Setting up your fab
Fig. 3-34 Automatic address assignment
The automatic address assignment routine starts to search automatically for existing fans. Automatic
address assignment takes place in two stages. All fans detected are shown in the list displayed and
then addressed in ascending order of the serial numbers in the second automatic stage. The serial
number displayed differs slightly from the one printed on the type plate. The 00 between the Production
date and the alphanumeric part is replaced by a blank space and the Calendar week and Year are
separated by a slash.
The address assignment process may take several minutes. Unfortunately, due to the method used, it is
not possible to predict how long it will take. However, EC-Control shows the status above the menu bar
of the dialogue. On completion of the process, the Continue button becomes available again. The
address assignment process can be terminated with Stop addressing. However, the corresponding fab
component can then no longer be used until correct address assignment has been performed.
Automatic address assignment can always be restarted if necessary. To do so, you only have to go
through the corresponding part of the configuration assistant. Click Continue on completion of automatic
address assignment.
If you are in Small size fab mode, continue reading in Chapter 3.1.1 with item 4. Otherwise continue in
Chapter 3.1.2 with item 8.
43