Download TouchWare for Windows User's Guide

54
TouchWare for Windows User's Guide
Additional ThruGlass Specific Commands
These commands can be used for diagnostics and configuration of
ThruGlass controllers.
Table 3: ThruGlass Specific Controller Commands
Command Name
ASCII Code
Description
Mode Noise
Extended Mode
Set Creep
Set Sensitivity
MN
MX
SC [pressed released]
SS [max/min adjacent unused
speed fast level release]
SF [freq]
SP [resln delay]
ST [0..3]
SCX [xtbl|X0 X1 X2 X3 X4 X5
X6 X7]
SCY [ytbl|Y0 Y1 Y2 Y3 Y4 Y5
Y6 Y7]
FRA
FBA
FZA
NOA
Stream noise data packets
Send firmware algorithm data on press
Set/show base update rates
Set/show touch algorithm parameters
Set Frequency
Set Phase
Set Type
Set Correction X
Set Correction Y
Format Raw ASCII
Format Base ASCII
Format Depth ASCII
Noise ASCII
Set/show frequency
Set/show phase
Set/show controller & screen orientation
Set/show X depth correction parameters
Set/show Y depth correction parameters
Show 16 sensor channel values
Show 16 base values
Show 16 press depth values
Show noise data
ThruGlass Command Line Commands
Sending ESCAPE,ESCAPE,ESCAPE will place the ThruGlass controller
into ‘terminal’ mode. The following commands are then active. Note that
some parameter values can render the controller inoperative. FR will return
the controller to factory default settings. Note that these commands are for
diagnostic use only and are not recommended for normal operation.
•
Enter either full command or abbreviation followed by <ENTER>.
•
Angle brackets indicate required parameter.
•
Square brackets indicate optional parameter(s).
•
Vertical bar indicates a choice must be made from list.