Download CPC user manual
Transcript
CPC March 1999 Card identification The card address (10 bits) is defined when it is tested after production. This is fixed. The address is the same as its serial number written on the white space. The address is used by the addressable JTAG controller to uniquely address a single card. When two cards in the FastBus crate are swapped, this cannot be detected via the addressable JTAG branch. Two provisions are implemented to deal with the problem: • Using a geographical read cycle in FastBus, the card’s serial number can be read. This serial number is used as an address in addressable JTAG operations. See the MPC register description on page 6 (Table 1: MPC registers). • Using a geographical write cycle in FastBus, an identifier can be written into C,3. It is useful to write the card location inside the FastBus crate into this register. The stored value can be read back via the addressable JTAG chain. See the FastBus control register description on page 6 and the JTAG register description on page 12 (Table 5: Mask/ test pattern, Instruction register). Both methods require access to the L3 FastBus TDCs. page 9