Download Operators Manual

Transcript
Remote Commands and Syntax
Commands
6
Table 6-5. Commands (cont.)
MACADDR?
Description
Sequential command. Returns MAC/HW address for LAN communication. The MAC
address is a unique assigned value and cannot be changed.
Parameter
None
Response
String
MACADDR?
Example
Returns six groups of hexadecimal numbers separated by colons (for example,
01:23:45:67:89:ab)
MULT
Overlapped command, ignored if not in remote.
Description
Multiplies the reference magnitude by the parameter and changes the output to the new
value. The reference magnitude is the present output in direct operation, and the
reference in error mode.
Parameter
Floating-point number to act as a multiplier
Example
If the output is 10 V with error mode off and the command is sent, "MULT 1.9", the output
changes to 19 V.
NEWREF
Sequential command, ignored if not in remote.
Description
Sets reference value to be the present output value. (The same as touching the New
Reference selection in local operation.)
Parameter
None
OFFSET
Description
Parameter
Sequential command, ignored if not in remote.
Enables and disables an offset for the output value. Effective immediately when enabled.
ON or OFF
OFFSET?
Description
Parameter
Response
Example
Sequential command.
Returns the offset value if the offset is enabled, otherwise, returns the number 0.0.
None
1.
(Float) Offset value or 0.0 if no offset is active
2.
(Float) Offset units
OFFSET?
Returns: "5.05000E-03,V" if an offset of 5.05 mV is active.
OHMSREF?
Description
Parameter
Return calculated resistance reference as shown in calibration report (average actual-tonominal ratio of the 100 ohm to 190 kohm resistors).
CAL
(From active calibration constants)
CHECK
(From calibration check constants)
PREV
(From previous calibration constants)
Response
(Float) The resistance reference value.
Example
OHMSREF? CHECK
1.000021902360723E+00
6-37