1
Download IBM SPSS Statistics 19 Core System User's Guide
Transcript
348 Chapter 19 /BARCHART. %%target_list%% is the value of the Identifier property for the target list control. At run-time it will be replaced by the current value of the Syntax property of the control. Defining the Syntax property of the target list control to be %%ThisValue%% specifies that at run-time, the current value of the property will be the value of the control, which is the set of variables in the target list. Example: Including Command Syntax from Container Controls Building on the previous example, consider adding a Statistics sub-dialog that contains a single group of check boxes that allow a user to specify mean, standard deviation, minimum, and maximum. Assume the check boxes are contained in an item group control, as shown in the following figure. An example of the generated command syntax would be: FREQUENCIES VARIABLES=var1 var2... /FORMAT = NOTABLE /STATISTICS MEAN STDDEV /BARCHART.
