Download USER MANUAL - Kramer Electronics

Installing the Room Controller(s) and the Wall Plates
To connect the SV-302, as the example in Figure 4 illustrates, do the following:
1. On the front of the SV-302, connect the:
Composite video source (for example, a DVD player) to the yellow
RCA connector, and to the unbalanced stereo audio RCA connectors
IR OUT 3.5mm mini plug via an IR Emitter1 Control cable directly
onto the IR sensor window of the controlled device (for example, a
DVD player)
2. On the rear of the SV-302, connect the RJ-45 CAT 5 connector to the
VIDEO 1 INPUT on the SV-551:
Figure 4: Connecting the SV-302 to the SV-551
1 The Emitter contains a small infrared LED housed in a miniature, mouse shaped, black plastic shell. It emits visible red light
in addition to IR (infrared) control signals when activated by IR commands sent to it by IR receivers or other controllers. The
Emitter Control Cable comes with a clear adhesive film included on the emitter housing for attachment to the IR window of
the controlled component and pieces of double-sided clear adhesive tape included for replacement purposes
17