Download NOVA-8522 User Guide

4.4.4.1 IDE Disk Drive Connector (IDE1)
The cable used to connect the ,otherboard to the IDE HDD is a standard 44-pin ATA
66/100 flat cable. To connect an IDE HDD to the motherboard, follow the instructions
below.
Step 1: Find the ATA 66/100 flat cable in the kit that came with the motherboard.
Step 2: Connect one end of the cable to the PIDE1 connector on the motherboard. A
keyed pin on the IDE connectors prevents it from being connected incorrectly.
Step 3: Locate the red wire on the other side of the cable that corresponds to the pin 1
connector.
Step 4: Connect the other side of the cable to the HDD making sure that the pin 1 cable
corresponds to pin 1 on the connector.Step 0:
NOTE:
When two EIDE disk drives are connected together, back-end jumpers on
the drives must be used to configure one drive as a master and the other as
a slave.
4.5 Chassis Installation
After the CPU, the cooling kit, and the DIMM modules have been installed and after the
internal peripheral connectors have been connected to the peripheral devices and the
jumpers have been configure, the motherboard can be mounted into chassis.
To mount the motherboard into a chassis please refer to the chassis user guide that came
with the product.
92
1-92