Download User's Manual

Transcript
SINE SAVER User’s Manual
SINE SAVER Trouble Shooting Guide
Symptom
Cause
Remedy
LCD backlight does not Input power wiring not Check input power wiring, refer to SINE SAVER
illuminate.
connected properly.
Electrical Installation Diagram.
Input voltage not within Measure the input voltage at SINE SAVER input
specification.
terminals. Check with specifications.
No 24VDC supply
Check output of SMPS
No line current.
Enable signal is not
active.
Check that the EN terminal is connected to +5V
Check that the ENABLED message is displayed.
V LIMIT message
appears continuously.
Input voltage has
exceeded maximum
rating.
See SINE SAVER General Specifications for input
voltage ratings.
OPT SC message
appears
Hardware level
protection in power
stack activated.
Check power components
OC
Line current was
greater than SINE
SAVER’s maximum
current.
Check system current ratings.
OV
message appears.
Input voltage has
exceeded maximum
ratings.
See general specification and check the input is
within ratings.
Ventilation problem.
Ensure operating ambient temperature is within
specification.
OT message.
Check input supply for voltage transients. Fix the
external source.
Check fans are rotating freely and there is no build
up of dust or debris in blades.
Visually examine the heatsink fins for build up of
dust and debris.
System is constantly
overloaded.
Check SINE SAVER continuous
ambient temperature rating.
IM00097B
current
and
Page 25