Download User's Manual

SINE SAVER User’s Manual
Warning
SINE SAVER must be applied, installed and operated in a safe manner in accordance with all local rules
and regulations. In particular, it is the system builder’s responsibility to address electrical safety,
machinery safety and electromagnetic compatibility issues. The system may also contain high energy
circuits that may be hazardous.
A typical SINE SAVER system will include capacitors that take greater than one minute to discharge
below 50Vdc. Ensure that all power sources are isolated and all capacitors discharged to a safe voltage
before working on any part of a the system.
Receiving
Inspect SINE SAVER for any shipping damage. If any damage is found, report it to the carrier
immediately. Access the inside of the controller and visually check for any damage.
Do not attempt to operate SINE SAVER if any damage is apparent.
After the initial inspection, SINE SAVER can be repacked and stored in a clean, dry location until it is
required for use. DO NOT store this equipment in an area where the ambient temperature will fall below
-20°C (-4°F) or rise above 70°C (158°F). DO NOT store this equipment in areas of high condensation or
corrosive atmosphere. Proper storage is necessary to ensure satisfactory controller start up and
performance.
Software
This manual applies to SINE SAVER software revision 1.02. The software revision is displayed
briefly at power up.
IM00097B
Page 5