1
Download Command Line User's Guide
Transcript
Chapter 38: Internet Protocol Version 4 Packet Routing Commands Passwords are sent in plaintext. The AT-S63 Management Software does not support encrypted passwords. Passwords are not supported in RIP version 1. poisonreverse autosummary Specifies the status for split horizon and split horizon with poison reverse. The options are: yes, on, true Split horizon with poison reverse is enabled. These values are equivalent. no, off, false Split horizon with poison reverse is disabled, and split horizon is executed. This is the default setting. These values are equivalent. Specifies the status of autosummary of routes. The options are: yes, on, true Activates autosummarization of routes. These values are equivalent. no, off, false Disables autosummarization. This is the default setting. These values are equivalent. Description This command adds RIP to an interface. It also controls the type of RIP packets sent to and accepted by the interface. This command is not available on the AT-9408LC/SP, AT-9424T/GB, and AT-9424T/SP switches. Examples This command adds RIP to the VLAN5-0 interface and configures the routing protocol to send and accept only version 1 packets. No password is specified since RIP version 1 does not support passwords. add ip rip interface=vlan5-0 send=rip1 receive=rip1 This command adds RIP to the VLAN10-0 interface and configures the routing protocol to send version 2 packets and accept packets of either version. Password protection is not used: add ip rip interface=vlan10-0 send=rip2 receive=both authentication=none 712 Section VII: Internet Protocol Routing
