1
Download Command Line User's Guide
Transcript
AT-S63 Management Software Command Line User’s Guide SHOW IPV6 MLDSNOOPING Syntax show ipv6 mldsnooping [hostlist] [routerlist] Parameters hostlist Displays a list of the multicast groups learned by the switch, as well as the ports on the switch that are connected to host nodes. This parameter displays information only when there are active host nodes. routerlist Displays the ports on the switch where multicast routers are detected. This parameter displays information only when there are active multicast routers. Description This command displays the following MLD parameters: MLD snooping status Multicast host topology Host/router timeout interval Maximum multicast groups Multicast router port(s) Host and router lists For instructions on how to set the MLD parameters, refer to “SET IPV6 MLDSNOOPING” on page 488. This command without optional parameters displays the information in Figure 68. MLD Snooping Configuration: MLD Snooping Status ................ Host Topology ...................... Host/Router Timeout Interval ....... Maximum MLD Multicast Groups ....... Router Port(s) ..................... Enabled Single-Host/Port (Edge) 260 seconds 64 Auto Detect Figure 68. SHOW IPV6 MLDSNOOPING Command Section III: Snooping Protocols 495
