Download Classic Client 6.1 for Linux User Guide - AD-NO
Transcript
3 Fingerprint Authentication This chapter provides information on fingerprint authentication in the Classic Client. Fingerprint authentication can be used as an alternative to PIN authentication. Fingerprint authentication is supported in the tasks mentioned in “Chapter 4 - Tasks”. About Fingerprints For cards that contain the IAS Classic Applet V3 and the Match On Card (MoC) applet, fingerprints can be used as an alternative to presenting a PIN. For fingerprint authentication, you must have a fingerprint scanner connected to the computer. (Please refer to the Classic Client Release Note to know which fingerprint scanners are supported.) To authenticate, place a finger on the sensor of the reader. Classic Client compares the digital fingerprint of the finger with the corresponding fingerprint stored in the MoC applet. Caution: As with PINs, the number of attempts to perform a fingerprint authentication is limited. After a pre-defined number of failed attempts, you can no longer perform operations that require fingerprint authentication. YOU CANNOT UNBLOCK FINGERPRINT AUTHENTICATION USING CLASSIC CLIENT. Requirements For fingerprint authentication to work, the fingerprints must already be present on the smart card. The smart card must have the MoC (Match on Card) algorithm loaded on it. Authentication Process If the requirements are fulfilled and the applications are configured properly, the applications should prompt the user to authenticate with a fingerprint as shown below.