Download User's Manual

DS10
Risks and Precautions
2 Risks and Precautions
ATTENTION
Following are listed the most important warnings to be fully comprehended and applied by
the user who, in case of non-complete comprehension or impossibility to apply them correctly,
must not use the product at all.
!
!
!
!
The DS10 drives are components. It is the user’s responsibility as the
installer to be sure the product complies with the rules and regulations
in force. The user must also be trained in the installation of the
electronic equipment to fully comprehend the features, the calibration
parameters and the indications contents of this guide.
The user must provide for the application of all the local safety laws and
regulations in force in the Country and/or application in which the
product is used.
The user must provide that the product is inaccessible while powered
on. The user must also consider that, because of the capacitors inside
the drive, it is necessary to wait at least for 30 seconds after the power
off before acceding to the drive. According to the external capacitors
eventually mounted on the power supply circuit, it is possible the user
shall have to wait for a longer time.
While working the product generates heat which can raise the
temperature of some parts (as the heat sink, for example) up to values
that can cause burns. Such a conditions remains for a long time even
after the product has been powered off. The user must provide for the
appropriate protections and signals, must train the operator, the
technical support and risk maintenance staff, and then must indicate it
in the service manual of the finished product.
The high performance drive is able to generate rapid accelerations with
high motor torque. Never touch any mechanical part while the drive is
powered on. The user must prearrange the application in order this
condition is always granted.
7