Download USER'S MANUAL

Transcript
13. Operating Procedure
This chapter describes the basic operating procedure.
The operating procedure starts with the software and the device in the connected status.
For the connection procedure, see Section 4, "Connecting to a PC (Personal Computer)".
The settings that are not addressed in the following sections are the factory default settings.
No.
q
w
e
r
t
Operation
Capture Settings
Start
Displaying past data during a data capture operation
Stop
Replay Data
Description
Make the settings required for data capture.
Start data capture.
Select Off for "Scroll" to display past data.
Stop data capture.
Replay data captured to the PC (personal computer).
13-1 Capture Settings
Click the "Capture Settings" button to make the settings required for data capture.
13-1-1 AMP Settings
Make the input settings shown below.
CH used
Input
Range
2 channels (CH 1 and CH 2)
CH 1: DC
CH 2: TEMP
CH 1: IV
CH 2: TC-T
Make the settings as shown in the following screen:
ALTHEN GmbH • Frankfurter Str. 150-152 • 65779 Kelkheim • Telefon +49 (0)6195 / 70060 • [email protected] • www.althen.de