1
Download Sheet Metal Design User Guide - John J. Jacobs
Transcript
Uncorrected Developments and Bend Allowance Other Bend Allowance Global Options Positional Tolerance This option sets the separating distance at which SMD considers points to be coincident (at the same position) or separate. You should only need to change this value when you see abnormal geometry in the output or when SMD reports problems. You can change the value by changing the setting of Positional Tolerance on the Bend Allowance Global Variables property sheet, as described on page 10-14. You can also change the positional tolerance on the Folder Global Data property sheet, as described in Step 1, in the section “Defining the Appearance of the Model” on page 11-3. Sheet Metal Design User Guide 10-31
