Download HP Moonshot-180G Command Reference Guide

Port Security Commands
HP Moonshot Switch Module CLI Command Reference
show port-security dynamic
This command displays the dynamically locked MAC addresses for the port. Instead of unit/slot/port, lag
lag-intf-num can be used as an alternate way to specify the LAG interface. lag lag-intf-num can also be used
to specify the LAG interface where lag-intf-num is the LAG port number.
Format
show port-security dynamic {unit/slot/port | lag lag-intf-num}
Mode
Privileged EXEC
Term
Definition
MAC Address
VLAN ID
MAC Address of dynamically learned MAC address.
The VLAN ID specified in the Ethernet frame received by the interface.
show port-security static
This command displays the statically locked MAC addresses for port. Instead of unit/slot/port, lag lag-intfnum can be used as an alternate way to specify the LAG interface. lag lag-intf-num can also be used to specify
the LAG interface where lag-intf-num is the LAG port number.
Format
show port-security static
Mode
Privileged EXEC
{unit/slot/port | lag lag-intf-num}
Term
Definition
Statically Configured MAC
Address
VLAN ID
Sticky
The statically configured MAC address.
The ID of the VLAN that includes the host with the specified MAC address.
Indicates whether the static MAC address entry is added in sticky mode.
Example: The following shows example CLI display output for the command.
(Routing) #show port-security static 1/0/1
Number of static MAC addresses configured: 2
Statically configured MAC Address
--------------------------------00:00:00:00:00:01
00:00:00:00:00:02
September 2014
VLAN ID
------2
2
Sticky
-----Yes
No
CLI Command Reference
Page 451