Download DPE Peripheral Setup Guide

Section 2 – VTR/ATR Performance & Setup
Audio Track
Section
A1, A2
Sync Control
Reference
Time Code, Tape Timer
Alt TC Ref
Selectable
No
Motion Control
Functions
Jog: Approximately 4 frames/Rev of Jogger control. Variable: From 100% to +300% Play Speed.
Programmed
Motion
[SLOW] key: Learn current variable speed into [SLOW] key with
[SHIFT][SLOW].
SLO-MO Match: Yes
VTR PROM Level Version 7.3
Record VTR E-E
Monitoring
Recommend using Dual Monitor Preview mode. VTR allows E to E
operation for source switching only in STOP or SHUTTLE modes.
Super Edit
Software
V7.0L or later
Ampex VPR-3 System Setup
The following tests verify VTR control setup and proper operation of the color framing
circuitry. The tests are general, but are designed to assist you in determining whether
any problems are in the VTR or Editing System.
Verify Input Signal Color Frame Detection
1. Connect a properly adjusted SC/H signal source to the VPR-3 input.
2. Connect a properly adjusted SC/H signal (Black) reference to TBC-3.
3. With no tape on the VPR-3, check the WRONG F/F light to be sure it is OFF.
This light is located at the top-right side of the SC/H Phase meter on the VPR-3
panel. If the light is ON, re-check steps 1 and 2, consult the VPR-3 Service
manual or call Ampex Service.
2-15