Download TransAct Ithaca 91PLUS Receipt Only Matrix Printer
Transcript
Programmer's Guide PcOS Series 90PLUS Communications Serial Port 8.3.7 Serial Port Inquire The serial port inquire is more straightforward than parallel mode. The serial acknowledged (ACK) or not acknowledged (NAK) responses follow a uniform format, the ACK or NAK is always followed by the command ID that requested it. This makes the design of the host application easier because the response can be identified and always follows the same format. The host sends an inquire to the printer asking for the form sensor status. The host receives the response and decodes it. The printer receives the request and preprocesses it. The printer responds with an [ACK] <id> or [NAK] <id> indicating the form sensor status. Figure 31 Inquire flow The host sends an [ENQ] <id> (form sensor status) request to the printer. The printer responds with an [ACK] <id> indicating that the request was identified, and the status is true. Inquire commands affect the printer’s performance. Printer communications are a high priority. Inquire commands take processing time away from print tasks. It is possible to ask for so much status that the printer slows down. In serial mode, it is important that the response to an inquire command be received by the host before another command is issued. When an inquire command is received by the printer, it is buffered in a highspeed processing queue. When the printer has time, it empties the queue and processes the inquires. The printer will respond to the command as soon as the second byte of the command is taken from the high speed buffer. If the host is looking for a form to be inserted, it should not send status requests as fast as it can. The host will get a response to all of them. If the host did not wait for a response to each, there would be unnecessary responses. In IEEE 1284 mode, inquiry responses are placed in an IEEE 1284 transmit queue. When the IEEE 1284 reverse channel is open, the responses are returned to the host. It is important that after each request the reverse channel be opened. Inquire responses will remain in the queue until read. If the [ENQ] <9> command is sent to the printer, the IEEE 1284 buffer will be cleared, and only the response to the [ENQ] <9> will remain. 12/16/99 Rev M Page 151