Download Simrad ER60 - REV B Technical information
Transcript
The menu system 6 Save Settings The Save Settings dialog is save operational settings. → Save Settings on page 94 Install menu The following functions and parameters are available from the Install menu. 1 Transceiver (Installation) The purpose of the Transceiver Installation dialog is to set up the necessary parameters to connect the EK60 computer to the transceiver(s) and the transducer(s). → Transceiver Installation on page 96 2 Navigation The Navigation dialog controls how the EK60 receives information from external peripherals, such as navigation and gyro compass systems. → Navigation on page 101 3 Motion The Motion dialog allows you to set up the EK60 to interface with an external motion sensor. → Motion on page 107 4 Trawl The Trawl dialog allows you to enter the main parameters related to the trawl. Trawl information is used for display of upper and lower trawl line in the echogram. All received speed data are stored to file when recording of raw data to file is enabled. → Trawl on page 109 5 Environment The dialog Environment is used to adjust the environmental parameters. These parameters are used for estimating range, propagation loss, and spreading loss, all of which are essential concepts in the echo sounder. → Environment on page 110 6 Annotation The purpose of the Annotations dialog is to allow you to enter comments and annotations into the echograms. → Annotation on page 112 164692/D 65